Open 24/7 · R350 call-out fee · Price agreed on site before work startsPay by EFT, cash or card
Lock problems

Garage Door Won't Open: Manual Release and Lock Faults

In short:

  • Many "dead" garage doors are a power cut, a remote problem, or a manual lock still engaged while the motor tries to lift the door.
  • The motor's manual release lets you work the door by hand. Use it only as your opener's manual describes, ideally with the door fully closed.
  • Springs and cables are under high tension. Never loosen, adjust or remove them yourself.
  • If the door feels very heavy, won't stay up or drops, stop and call a professional.

First, which kind of door do you have?

The type of door decides where the springs sit, how the motor drives it and what kind of manual lock it carries.

Common garage doors
DoorHow it movesWhere the spring force isTypical manual lock
SectionalHinged panels run up and back on tracks in a rough L shapeTorsion springs on a shaft above the door, or extension springs alongside the horizontal tracksA centre handle lock, or slide bolts at the sides
RollerA curtain of slats coils around a barrel above the openingA spring inside or on the barrelA centre lock or bottom bolts, sometimes with a padlock
Single-panel tiltOne panel swings up and overSprings at the sides of the frameA centre handle lock with rods to the frame

With a motor fitted, the opener itself usually holds the door in place. That's why the manual release and the manual lock matter so much when something goes wrong.

Why it won't open: symptoms and likely causes

Reading the symptoms
What happensPossible cause
Nothing at all from the remote or the wall buttonNo power to the motor, a tripped circuit, or the motor's own fault
Wall button works, remote doesn'tRemote battery, a remote that's lost its pairing, or a receiver problem
Motor hums or strains, door doesn't moveThe manual lock is still engaged, the door is jammed in its track, or a spring has broken
Motor runs but the door stays putThe manual release has been pulled and the opener isn't reconnected
Door lifts a little, then reversesAn obstruction, a safety beam out of line, or the door is out of balance
A loud bang earlier, door now very heavy or crookedA broken spring or cable
Key won't turn in the manual lockA seized cylinder, a broken key, or bent lock rods

Chamberlain, a garage door opener maker, tells owners to disable any door locks before operating an opener. A manual lock left engaged is one of the simplest causes of a motor straining against a door that can't move.

The manual release: follow your opener's manual

Every motorised garage door has a way to disconnect the door from the motor so it can be moved by hand. On ceiling-mounted openers it is usually a cord with a handle hanging from the carriage on the rail; wall-mounted openers have their own release. ET Nice's installation instructions require the emergency release to be fitted no higher than 1.8 m from the floor and say users should be shown how to use it.

Manual lockSpring under high tension:never adjust or touchCarriage on the railManual release cord and handleMotor Release with the door fully closed where possible. Never use the release handle to lift or pull the door.
Illustration A sectional door with a ceiling-mounted opener. Your door and opener may look different; their manuals are the authority.

Chamberlain's guidance makes the safety points plain: use the emergency release only when the door is fully closed if possible, never pull the release handle to raise or lower the door, keep people, pets and objects clear, and stop immediately if the door feels unusually heavy, won't stay open or slams shut. Weak or broken springs can let a door fall fast and without warning. Reconnecting the opener afterwards is also done the way the manual describes.

If you can't find the manual, look for the maker's name on the motor cover and find its instructions online before touching the release.

Springs and cables: don't go near them

Garage door springs and their cables hold a great deal of stored energy. Chamberlain says never to loosen, move or adjust springs, cables, pulleys, brackets or their hardware, and to call a trained door technician if the door binds, sticks or is out of balance. ET Nice's instructions say balancing springs should only be adjusted by a trained, experienced person. Wikipedia's article on garage doors notes that many people have been injured or killed trying to adjust torsion springs.

Signs of a spring or cable problem you can spot from a safe distance: a gap in a coiled torsion spring, a cable hanging loose, the door sitting lower on one side, or a bang from the garage when nobody was using it. If you see any of these, leave the door closed and call.

Safe checks before you call

  • Check whether the house has power, and whether other things in the garage are working.
  • Try the wall button as well as the remote. If only the remote fails, try a second remote.
  • Look at the manual lock. Is the handle turned or are the side bolts across?
  • Look for anything in the doorway, and check that the safety beam units on either side are clean and facing each other.
  • Look at the springs and cables from the floor without touching them.
  • If the car is trapped inside, don't try to nudge the door with the bumper. Make another plan for the day.

What makes it worse

  • Pressing the remote over and over while the motor strains against a locked or jammed door.
  • Lifting a heavy door by hand after a spring has broken. Its full weight is on you, and it can drop.
  • Prying the door at the bottom or forcing the lock with a bar.
  • Leaving the door disconnected from its motor and unlocked overnight. Lock it with its manual lock until the opener is reconnected.
  • Letting children play with the remote or the wall button, which ET Nice's instructions specifically warn against.

When to call us, and what helps

Call when the door won't move safely by hand, when a spring or cable looks wrong, when the manual lock is seized or the key has broken, or when the motor won't run. Garage doors and their locks, mechanisms, springs and motors, as well as gate motors, are normal work for us under our lock repair service. If the lock itself is worn out, see lock replacement. We work 24/7: R350 call-out fee. The technician assesses the job on site and gives you the price before any work starts. Nothing is done until you agree.

  • Photos of the door from inside and outside, the motor with its label, the springs from a distance, and the manual lock.
  • The door type: sectional, roller or tilt.
  • What you heard or saw when it stopped working.
  • Whether a car is stuck inside and whether the garage is your only way into the house.
  • In an estate, a heads-up to the guardhouse that a locksmith is coming.

Lost a remote, or someone with one has moved on? We don't copy remotes. Most receivers can erase remotes from their memory: ET Nice's manual, for example, has an "Erase remotes" option in the receiver menu. Our guide to changing locks when household staff leave covers that in more detail, and a night-time lock-up routine includes the garage. We cover homes right across Durbanville, from Sonstraal Heights to Everglen; our Durbanville mobile locksmith homepage lists everything we do.

Questions

If I pull the manual release, can I just drive out?

Only if your opener's manual allows it in your situation and the door moves easily and stays where you put it. If it's heavy, won't stay up or drops, stop, lower it carefully if you can do so safely, and call for help.

Do you work on garage door motors and springs, or only the lock?

Both. Garage doors and their locks, mechanisms, springs and motors are everyday work for us, and so are gate motors. The technician checks the door and quotes on site first.

Can you set up a new remote for a lost one?

We don't copy remotes. Follow your motor maker's instructions to remove the lost remote from the receiver, and use the remotes you still have. If the receiver or motor itself is faulty, that's something we can look at.

Need a locksmith to look at it?

If this hasn't solved the problem, our lock repairs service covers it. We're a mobile locksmith in Durbanville, so we come to your door.

Sources and further reading

  • Chamberlain: How to manually open or close a garage door — Use the emergency release only with the door fully closed if possible; never pull the release handle to raise or lower the door; stop if the door is heavy, won't stay open or slams; weak or broken springs can drop the door; disengage a manual lock first.
  • Chamberlain: How to test the balance of a garage door — Never loosen, move or adjust springs, cables, pulleys or brackets; call a trained technician if the door binds or is out of balance; disable locks before operating the opener.
  • ET Nice: Drive 500/600 installer instructions (copy hosted by ismartgate) — Emergency manual release no higher than 1.8 m (the cord in a garage installation); users shown how to use it; garage balancing springs adjusted only by a trained, experienced person; children kept away from remotes; receiver menu includes Erase remotes.
  • Wikipedia: Garage door — Sectional, rolling and single-panel doors; torsion and extension springs; broken springs can drop a door; many people injured or killed adjusting torsion springs.

Request assistance

Four quick details. We reply by phone or WhatsApp, 24/7. For anything urgent, calling is quickest.

We use these details only to respond to your enquiry. See our privacy notice. Sending this form is a request for contact, not a confirmed booking.

CallWhatsApp